The Vicks V400 Cool Mist Humidifier is an impeller humidifier and differs from a standard evaporation device.Evaporation humidifiers use a fan to blow air through a saturated filter.Impeller humidifiers do not have a fan, but instead use a rotating disk to break water into droplets.The droplets leave the face of the unit and float into the air to humidify the environment.The V400 features a DynaFilter that cleans allergens out of the air.Operation of this unit is straightforward and takes just minutes to set up.Set the humidifier on a flat, solid surface, like a table or the floor.Remove the wrapping on the DynaFilter cartridge.Slide the cartridge into the recessed slot located on top of the humidifier.Replace the filter when accumulated dirt becomes visible.Grasp the housing on both sides and pull up to remove.Place the housing to the side.Set the housing upside down to avoid damaging the pickup tube on the inside surface.Use a pitcher to pour water into the inside of the unit.The water storage compartment is internal and does not come out.

You must bring water to the machine.Fill to the line on the side of the compartment.Check the on/off switch.It should be set to off or the “0” position.Plug the unit into a nearby wall socket.If you must use an extension cord, use a 12-10 gauge appliance cord.Turn the unit to “On” once plugged in.Wipe the unit down after use.Turn the unit off and unplug the cord.Rinse the base of the unit under running water.Dry the base and housing with paper towels.Vicks advises to never clean the housing with water.This may result in electric shock.Remove the pickup tube from the inside of the housing once a week.Grasp the tube with your fingers and rotate the disk towards the “Off” label on the housing.Soak the tube in a bowl of undiluted white vinegar for 20 minutes.Dampen a cloth with vinegar and wipe down the base and housing.Rinse the base and tube with water and reassemble the humidifier.Dry the housing with a paper towel or cloth.Disinfect the unit several times a year.Fill the water compartment in the base with 1 tsp.

of bleach and 1 gallon of water.Place the pickup tube inside the base.Soak for 20 minutes.Rinse the base and tube under running water.Dry the unit with a clean cloth.Water Paper towels Cloths White vinegar Bleach Gain 2 pounds per week Gain 1.5 pounds per week Gain 1 pound per week Gain 0.5 pound per week Maintain my current weight Lose 0.5 pound per week Lose 1 pound per week Lose 1.5 pounds per week Lose 2 pounds per week How to Clean a Cool Mist Humidifier How to Use a ReliOn Humidifier How Does a Cool Mist Humidifier Work?How to Clean a Vick's Humidifier Filter How to Use Vicks Humidifiers The Pros & Cons of Humidifiers Tips on Running a Cool Mist Humidifier Can a Cool Mist Humidifier Be Used in the Summer?Why Do I Need a Humidifier?Humidifier Are Humidifiers or Vaporizers Good for Infants?Benefits of a Whole-House Humidifier How to Clean a Vick's Warm Mist Humidifier How to Clean Mineral Deposits From a Humidifier Cool Vs.

Warm Mist Humidifiers The Benefits of an Air Humidifier How to Clean Humidifier Filters with Vinegar Ion Humidifier Vs.good cheap vape setupUltrasonic Humidifier How to Put Essential Oils in Crane Humidifiers Vaporizer Uses and Remediesvolcano vaporizer easy valve reviewClean your Cool Mist humidifier near a sink or bathtub.vaporizer pen review 2014Breathing can be such misery when you have a cold, the flu, or sinus problems.dodo vaporizer pen reviewVicks Cool Mist humidifiers are designed to help provide temporary relief and soothe cough and congestion.viva la vape patriot review

These humidifiers use special filters designed to remove dust, pollen, smoke, and other odors and contaminants during operation.viva la vape ally reviewWith use, the filters become dirty and require changing.But changing the filters alone won't keep your Cool Mist hygienic.Scale from hard water and other contaminants can clog the humidifier, and microorganisms -- especially germs and bacteria -- can grow inside the humidifier.Keep your Cool Mist clean, and yourself feeling better by performing regular maintenance.Turn the Cool Mist off.Unplug the cord from the wall outlet.Perform daily cleaning on a stable, flat surface with adequate space.Pull out the water tank, then the water tray, on models with a removable container, such as the V3100.Both parts attach to the Cool Mist base, and freeing the tank allows you to lift out the tray.Work carefully to avoid damaging the wicking filter.On a Cool Mist without a water tank, such as the V400, take off the top housing and lay it upside-down on a flat, stable surface.

Avoid resting the housing on the water pickup tube, which may damage it.Remove the water tank's cap and empty of any remaining water, then flush the container with fresh, warm water -- not hot -- for models with a water tank separate from the water tray (V3100).On Cool Mist models lacking a water tank and using the base as a water reservoir instead (V400), empty the base of any remaining water, flush with warm water, then wipe it down with a fresh, clean cloth or paper towel to dry it.Wipe down all the areas you can get to on the water tank and water tray (V3100).Run a clean, dry cloth (moisture may cause electric shock) over the exterior of the top housing (V400).Clean the remainder of the unit -- the base and cord -- with a slightly damp cloth as needed, no matter which model you own.Keep water clear of dials, vents, and other electronic or mechanical access areas.Empty the removable water tank, flush it with warm water, then temporarily set it aside (V3100 and V3900).Turn on the V3100, or similar models of Cool Mist humidifiers, and with the tank removed, allow air to flow through the wicking filter.

Stop when the filter is completely dry.Turn off the humidifier and unplug it from the wall.On models such as the V400, which lack removable water tanks, turn off the humidifier and unplug it first.Next, remove the top housing (avoid resting it on the pickup tube), dump out any remaining water, then wipe down and dry similar to daily cleaning.Lift the wicking filter from the water tray, gently pulling straight up to avoid tearing the filter.This applies to both the V3100 and the V3900.Vicks' V400 is slightly different, using cartridge filters that fit into the top housing.Instead of cleaning these filters, they are replaced as needed.Pull out the water tray to separate it from the base on a V3100.Pour a cup or two of undiluted vinegar into the tray and allow it to set undisturbed for 20 to 30 minutes.The vinegar loosens scale deposits water leaves behind.For models V400 and V3900, dampen a cloth or sponge with straight vinegar, then wipe out the inside of the base to remove scale.Rinse with warm water.

Detach the pickup tube on the V400 to thoroughly clean the unit.With the top housing turned upside-down, rotate the tube in the direction the arrow indicates.Drop the tube in a small bowl of undiluted vinegar, and soak for about 20 minutes to loosen scale deposits.In the meantime, wipe down the interior of the top housing with a vinegar-dampened cloth or sponge.Get the area around the pickup tube hole as well.Wipe the entire interior of the V3100's water tray, using a cloth or sponge already wet with vinegar -- like you're washing the inside of a roasting pan or similar dish.This removes scale deposits already loosened during the vinegar soak.Dump out the vinegar when you're finished, and rinse with warm water.Rinse the Vicks Cool Mist V400's pickup tube with warm water.Run the water through the tube as well as on the outside.Clean the exterior of any Vicks Cool Mist humidifier every week to keep the unit clean and looking presentable.Use a dry cloth to clean the exterior around inlets, outlets, filters, and electrical or mechanical parts.

Dampen the cloth to clean the underside, where appropriate, as well as the power cord.Fill the water reservoirs of any model of Vicks Cool Mist humidifiers, using a mixture of 1 teaspoon bleach per gallon of water.If you own a V400, place the detached pickup tube in the bleach-water-filled base and allow it to soak as well.Wait 20 minutes, stirring the water occasionally or rotating the container, to spread the bleach and penetrate every part.Wipe down every other interior surface, no matter which model, with a cloth or sponge dampened in the bleach water.Avoid abrasive cleansing agents, and do not expose mechanical or electrical parts, or similar areas to the bleach water.Pour out the bleach water.Remove the pickup tube on the V400 first, then pour carefully to avoid exposing vulnerable areas of the humidifier if applicable to your model.Rinse each base or water reservoir completely with warm water.Flush the pickup tube on the V400 as well.When the bleach smell is gone, it is flushed well.